Table of Contents
Advertisement
Programming the Remote Control
This section explains how to program your remote to control your
television and VCR. This will allow you to adjust the volume, turn the
television on and off, change channels, and control your VCR.
Programming for Television Operation
The remote control is already preprogrammed to control the
DISHPlayer receiver. To program the remote to control your
television, do the following:
1.
Find the three-digit code for your TV manufacturer in the Televi-
sions table on page 8. Use the first number listed if more than one
set of numbers appears for your TV.
2.
Set the TV/VCR SAT mode switch on the right side of the remote
control to TV/VCR.
3.
Press and hold the CODESET button on the left side of the
remote control for six seconds.
4.
Enter the appropriate three-digit code, which you found in step 1
for your television model.
5.
Press ENTER.
6.
Set the TV/VCR SAT mode switch back to SAT.
7.
Verify that the code works by pressing the Volume button on the
remote (see below).
8.
For quick reference, write the number from step 1 down in the
table on the inside of the back cover of this manual.
The remote control is now programmed to control your TV.
To verify that the remote control operates your TV
With your TV turned on, press the Volume + on the remote control. If
the remote does not change the volume on your TV, repeat the steps
above using a different code listed for your TV manufacturer.
Programming for VCR Operation
To program the remote to control your VCR, do the following:
1.
Find the three-digit code for your VCR manufacturer in the VCRs
table on page 9. Use the first number listed if more than one set of
numbers appears for your VCR.
2.
Set the TV/VCR SAT mode switch on the right side of the remote
control to TV/VCR.
3.
Press and hold the CODSET button on the left side of the remote
for six seconds.
4.
Enter the appropriate three-digit code, which you found in step 1,
28
Advertisement
Table of Contents
