Resetting To Factory Defaults - Dish Network Solo ViP 411 User Manual

Chapter 10

Resetting to Factory Defaults

but there is only PCM audio in the program, you will hear nothing. This also applies to the
analog audio outputs.
• Line Mode. When you use this setting, in comparison to RF Mode, the dynamic range
is wider, which makes the music and loud noises louder, but voices quieter. This set-
ting is good if you don't mind turning the volume up louder to hear the speaking por-
tions of programs.
• RF Mode. When you use this setting, in comparison with Line Mode, the dynamic
range is narrower, which makes music and loud noises quieter, but voices louder. This
setting is good if you need to keep the volume lower.
4
If Volume Leveling is desired, select Enable to turn on Volume Leveling. Volume leveling
keeps the volume levels consistent between programs and commercials, preventing
drastic volume changes while watching television.
Note: When volume leveling is enabled, only the digitial PCM and RCA analog line
outputs are affected.
5
Select Done.
R
ESETTING TO
You can reset the receiver to discard any changes you have made to the receiver, except
for remote control address setting and locks. Resetting the receiver to factory default
settings also discards all Favorite Lists except the All Chan, All Sub, and All HD lists.
If you have set any locks on the receiver, and the receiver is locked, these locks will be
kept. If the receiver is unlocked, any such locks will be lost. You cannot reset the receiver
to default settings to discard a password you have forgotten. No one but a Customer
Service Representative can reset the receiver to bypass a receiver lock.
1
Press MENU, select System Setup, and then Factory Defaults. The receiver displays a
Warning message to confirm that you want to reset the receiver's preferences.
2
Select Yes.
84
F D
ACTORY
1
System Setup 6
Factory Defaults 4
Press Menu, then System Setup
and Factory Defaults
EFAULTS
2
Select Yes.
STB returns to
Factory Defaults.