Dish Network Solo ViP 411 User Manual page 69

Turning Limited Mode On and Off
Press and hold the
correct Mode button until
all Mode buttons light.
Release Mode button
1
Press and hold the correct mode button (for example, TV) until all of the mode buttons
light. Release the mode button.
2
Press:
• PAGE UP to turn Limited Mode on.
• PAGE DOWN to turn Limited Mode off.
3
Press POUND (#).
SAT Auto-Tune
The SAT Auto-Tune feature, which is enabled by default, sends the correct TV channel for
viewing satellite TV when you select the SAT mode button on the remote control.
SAT Auto-Tune can only send a channel to the TV, not an input. Because of this, SAT
Auto-Tune is most useful for TV2. If used for TV1, channel 3 or 4 should be programmed
using the steps under Setting SAT Auto-Tune Channel. The TV channel programmed for
SAT Auto-Tune is also the channel that will be sent to the TV if the RECOVER button is
used. The steps in Setting SAT Auto-Tune Channel can also be used in VCR mode to
program the channel sent to a VCR during the Recover process.
For SAT Auto-Tune to function correctly, the correct channel for the installation must be
programmed into the remote using the steps under Setting SAT Auto-Tune Channel.
Remote Control Setup
Press PAGE UP to
turn Limited Mode on.
Press PAGE DOWN to
turn Limited Mode off
Operating Other Devices
Press POUND (#)
59