SABINE SW71-NDR User Manual page 7

Transmitter Controls
1 Select Button
2 Up Button
3 Down Button
1
5 1. Turn on the transmitter.
2. Use the SELECT button until CHANNEL appears in the LED. NOTE:
the transmitter is muted during editing.
3. Use the UP or DOWN button until the desired channel appears above
CHANNEL.
4. Check that the receiver's RF SIGNAL display now indicates a strong
signal (at least 3 bars).
6 Gain Adjustment Settings
1. Transmitter (PAD Adjustment). Adjust the Transmitter PAD setting if
last segment of the Transmitter or Receiver Audio Level Meter lights up
often, or remains on when mic or beltpack is used.
1. Use the Transmitter Select button to scroll through functions
until PAD flashes in the Transmitter LCD.
2. Use the Up or Down buttons to select the desired setting. Se-
lection is stored after 3 seconds of inactivity.
3. Check to see if Audio Level Meter stays out of Clipping Zone
2. Receiver. Adjust the receiver Output Level to supply a strong input level to the mixer, amplifier or active
loudspeaker. If your receiver output is connected to a microphone level input on the mixer, keep the receiver output
gain lower than when connecting to a line level mixer input. NOTE: -10 is a good place to start.
3. Mixer. Adjust the output gain of the mixer so that the mixer output meters approach clipping when all the inputs
to the mixer are active, and the audio program reaches its peak level.
4. Amplifier/active loudspeaker/crossover.
one is used) to provide the desired level of sound pressure in the auditorium or listening area.
See Section 4.2.3 Adjusting Transmitter Settings for more information.
2
To Open: Unscrew
lower portion of mi-
crophone. Pull down
as you continue to
turn the housing.
To Close: Turn the
3
housing and push up
until it meets the
threads, then screw
on.
Finally, adjust the amplifier gain control (and/or crossover gain, if
7
Quick Setups
Beltpack Opening/Closing Instructions
To Open: Pull down on both battery door
releases and then pull door open.
To Close: Push door up and snap closed.
ON ON ON
OFF MUTE ON
2.4 GHZ SMART SPECTRUM
SELECT
Adjust PAD setting so that
Receiver Audio Level Meter
stays out of the clipping
zone (last segment)
Sabine 2.4 GHz Smart Spectrum
1 2
SELECT U P DOWN
3
®
Wireless
LIT-SWM7000-OG-EN-070615.pmd - rr