Accessing Transmitter Controls - SABINE SW71-NDR User Manual

4.2.2. Accessing Transmitter Controls

Control of all your transmitter functions is made using the Select button and
the Up/Down buttons. These control buttons are located inside the access
compartment on the beltpack or handheld transmitters.
Opening the Beltpack Transmitter Access Compartment:
1. Using your thumb and forefinger, grab both tabs and simultaneously pull
down toward the bottom of the beltpack. This releases the locks.
2. Gently pull the door open.
Closing the Beltpack Transmitter Access Compartment:
3. Swing the door back up and close it by firmly pushing the top part of the
door in until you hear the locks click.
Opening the Handheld Transmitter Access Compartment:
1. Unscrew lower portion of the case. Continue turning as you pull down.
Closing the Handheld Transmitter Access Compartment:
2. Begin by turning the lower portion of the case as you push up. When
threads meet screw on until snug.
NOTE: Do NOT attempt to unscrew the mic capsule from the body. This will
void your warranty!
BEFORE CHANGING BATTERY
Turn off transmitter before changing battery(s).
Transmitter LCD Display Indicators
SW70-H1
SW75-T
Fig. 4f: Start up Transmitter LCD displays
CHARGE: Illuminates when the transmitter battery is being charged (i.e.,
when the charger is connected, either by direct plug-in or by placing the
handheld mic in the Sabine charging clip).
BATTERY VOLTAGE LEVEL METER: Indicates measured battery voltage;
the more segments illuminated, the higher the voltage, and the greater
the remaining battery life.
AUDIO LEVEL METER: Shows the audio output level of the transmitter
(affected by the pad setting).The last and largest segment indicates clip-
ping.
PARAMETER VALUE: In default mode this indicates the RF TRANSMIS-
SION CHANNEL chosen for the transmitter. In conjunction with the Select
button (see figures 4b & 4c), this field will also display battery run-time
hours, or when a low frequency roll-off filter or an attenuation (pad) is
active (see Fig. 4g).
"TIME": Displays when battery run-time hours are being displayed.
"MUTE": Indicates output is currently muted.
"PAD": Illuminates when the microphone pad is turned on. Use this if the
audio meter shows clipping.
"MIC" INSTR": Indicates SW75-T beltpack (only) is set to accept either
mic or intrument input.
"ON": Illuminates when either the audio and RF transmission, or the RF
transmission only, are turned on. (SW70-H1 only)
"CHANNEL": Illuminates in default mode to display transmission channel.
13
Transmitter Operation
Fig. 4d: SW75-T
1
3
1
Fig. 4e: SW70-H
Sabine 2.4 GHz Smart Spectrum
LIT-SWM7000-OG-EN-070615.pmd - rr
2
2
®
Wireless