Navigator Remote Control Screens - SABINE 2007 NAVIGATOR Manual

S S : U
ECTION IX SING

6.5. NAVIGATOR REMOTE CONTROL SCREENS

Connection Screens
These screens are used for making the software connection to your Navigator in Live
Mode. See section 6.3 for more information on connecting your Navigator.
Connection Setup Screen
Main Screens
There are two ways to view the main screen: Mixer or Matrix, as shown on the following page.
Guide to Main Screen Menus:
•
File (Open, Save, Open Setup, Save Setup, New Setup, Exit): Open and Save refer to the
.NDAT files which are used to store and recall parameters of the Navigator on your com-
puter. These are equivalent to Programs, which are stored in the Navigator. Setup files are
used to save other parameters. Think of Setups as your screen sets and network set-
tings. Custom desktop arrangements can be saved and recalled. Links between units are
also saved in Setups (.XST files). See section 6.6 Saving Your Work for a complete
explanation.
•
View: Displays the values for every parameter in the Navigator. You can print these from
here, too.
•
Device: Choose which Navigator to control when connected to a Navigator Network.
•
Function: (Link, Copy, Reset All, Security, Device Name, Preferences) Link opens the
screen where you can establish multiple link groups and link any parameter across any
number of Navigators. Copy opens a screen that allows for flexible copying of any param-
eter to any Navigator. The Security screen provides for password creation and selection of
which front-panel menus will be locked when using a password. Device Name is just that,
and Preferences allows for default units for delay, EQ bandwidth, and temperature.
• Program: From here you can recall or save a Program into the memory of the Navigator
(rather than as a file on your computer). All programs stored within your Navigator can be
transferred to your PC using Upload All to PC. You can also transfer the files stored on
your computer to the Navigator as programs using Download All to Device. See section
6.6 Saving Your Work for a complete explanation.
•
Connection: Setup allows you to choose how to connect to one or multiple Navigators.
This window is also displayed when you choose Live Mode from the welcome screen.
Connect to the Navigator via RS232or USB as well as Ethernet (NAV4802 or 8802 only).
26
N R C
AVIGATOR EMOTE ONTROL
S
OFTWARE
Connection Status Displays
1. The green area on this screen says "Connecting," which
indicates your computer and the Navigator establishing the
control connection.
2. When the connection is successful you will see the
message "Up Sync OK" (shown below) and then "Link OK."