SABINE 2007 NAVIGATOR Manual page 20

General System Parameters
· FREQ MODE: Selects the frequency control mode for EQ and
crossover filters. The coarse adjustment is 36 steps/octave;
choose All Frequencies (1 Hz resolution) for fine adjustments.
· DELAY UNIT: ms (milliseconds), ft (feet), or m (meters).
Communications
· PORT: Choose control port. RS232/USB for direct connection
to a computer, or CAT-5 for Ethernet.
· BAUD: Choose the baud rate to match your serial port when
connecting via RS232 or USB. The values are 1200, 2400, 4800,
9600, 19200, 38400, 57600, or 115200.
· DEVICE#: Assigns the device ID from 1 to 16. Assigning ID numbers is required when you are creating
a network of more than one Navigator.
Security
The Navigator enables the user to secure the unit and prevent undesired changes in the setup. In order
to make changes to the security levels the user must enter the correct password.
· MENU - Selects the menu to be locked/unlocked. The options are:
•
In-Signal: Input Signal Menu (Level, Polarity, Delay).
•
In-EQ: Input EQ Menu.
•
In-Name: Input Channel Name Menu
•
Out-Signal: Output Signal Menu (Level, Polarity, Delay).
•
Out-EQ: Output EQ Menu.
•
Out-Xover: Output Crossover Menu.
•
Out-Limit: Output Limit Menu.
•
Out-Source: Output Source Menu.
•
Out-Name: Output Channel Name Menu.
•
Global Parameters: Global Parameters Menu
S F
ECTION IVE
NAV240, 360, 480
NAV4802 & NAV8802
NAV4802 & NAV8802 NAV240, 360, 480
NAV4802 & NAV8802 NAV240, 360, 480
: O N
PERATING THE AVIGATOR
Navigator2 Op Guide 071010 KJS.pmd
19