SABINE 2007 NAVIGATOR Manual page 19

S F : O
ECTION IVE PERATING THE
Program Store
The Navigator has a built in non-volatile memory that can store up to 30 different program setups. A
program can be stored using this menu. The old program with the same program number will be replaced.
Once the program is stored in the flash memory, it can be recalled at a later time, even after power down.
· PROG: Program Number for the current data to be stored.
· NAME: Program Name, allows a maximum length of 12 characters.
Configuration
· MODE - configures the mode of operation.
Stereo 2-Way
Stereo 3-Way
Stereo 4-Way
The unit assigns the Input source for the corresponding outputs when the Mode of Configuration is
selected. The crossover point parameters like the filter type, cut-off frequency and slope have to be
configured manually in the Xover Menu in each Output menu.
*Note: The configuration mode configures the input sources when selected. The user can change the
source afterwards if desired. It does not keep the configuration in memory.
Copy Parameters
Copy channel parameters from the source to the target. When
the Source and Targets are both Inputs or Outputs, all audio parameters will be copied. When one of the
Source or the Target is an input while the other is an output, only the Level, Polarity, Delay and EQ are
copied.
· SOURCE: Channel to be copied from.
· TARGET: Channel to be copied to.
18
N
AVIGATOR
Mode: Out 1 Out 2 Out 3
None Any Any Any
In1 In1 In2
In1 In1 In1
In1 In1 In1
NAV4802 & NAV8802 NAV240, 360, 480
NAV4802 & NAV8802 NAV240, 360, 480
Out 4 Out 5 Out 6
Any Any Any
In2 Any Any
In2 In2 In2
In1 In2 In2
NAV4802 & NAV8802 NAV240, 360, 480
Out 7 Out 8
Any Any
Any Any
Any Any
In2 In2