Appendix G - The I/O Terminal Block - Axis 2400AM Administration Manual

AXIS 2400/2401 Admin Manual

Appendix G - The I/O Terminal Block

Typically used in association with programming scripts for developing applications for
motion detection, event triggering, time lapse recording, alarm
notification via e-mail, picture storage to FTP locations and a
variety of other functions; the 16-pin I/O Terminal Block is
located on the rear panel and provides the interface to: a
single relay switch output, four digital photo-coupled inputs,
an RS-485 interface, and auxiliary power.
This appendix describes the pinout, interface support and the
control and monitoring functions provided by this connector.
Connector Pinout
The pinout for the Terminal Block (illustrated right) and signaling details for each pin is
fully described in the table below:
Pin Function
1 Auxiliary AC Power Input
2 Auxiliary AC Power Input
3 Digital Input 3 - Photocoupler Anode (+)
4 Digital Input 3 - Photocoupler Cathode (-)
5 Digital Input 4- Photocoupler Anode (+)
6 Digital Input 4 - Photocoupler Cathode (-)
7 RS-485 - B (inverting)
8 RS-485 - A (non-inverting)
9 DC + Power (Input or Output)
10 DC - Power (Input or Output)
11 Digital Input 1 - Photocoupler Anode (+)
12 Digital Input 1 - Photocoupler Cathode (-)
13 Digital Input 2 - Photocoupler Anode (+)
14 Digital Input 2 - Photocoupler Cathode (-)
15 Relay Switch
16 Relay Switch
Note:
For compatible replacement connectors, contact http://www.phoenixcontact.com, quoting:
MC1.5/8-ST-3.81 (art no 1803633).
Description
Electrically connected in parallel with PS-D power connector, pins 1 & 2
provide an auxiliary connector for mains power to the unit.
Photocoupled Input 3: Electrically isolated from the chassis and connec-
tors, this input can be supplied from an external DC voltage or the DC
Power Input/Output on pins 9 and 10.
Photocoupled Input 4. As above.
Serial Port 1- RS-485. A half-duplex RS-485 interface for controlling
auxiliary equipment. Note: Serial Port 1 is programmed as either
RS-232 (COM1 Connector) or RS-485 (Terminal Block Connector), via
the browser interface.
DC Power Input or Output: Used as an input, this supplies the Axis 2400
via a DC source; for example a solar panel or a battery.
As an output, it can drive the photo coupler inputs or other equipment;
such as an IR-sensor. The output voltage level is dependent upon the
input voltage to the unit. A maximum current of 50mA can be sourced
from the DC output.
Pin 10 is connected to the unit chassis, and Ground on each serial port
and video input. See circuit diagram (below).
Input 1 Photo coupler input. As Input 3.
Input 2 Photo coupler input. As Input 3.
Relay switch - electrically isolated from chassis and connectors.
The I/O Terminal Block
53