Page 1
AUTO CHARGE 35/10 AUTOMATIC BATTERY CHARGER MODEL #091-35/10 INPUT :120 volt, 50/60 Hz, 10 amps OUTPUT: 35 AMPERES 3 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796-1221 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826...
Page 2
Introduction The AUTO CHARGE 35/10 is a compact, completely automatic, single channel battery charger designed for vehicles with a single battery system. The charger is ruggedized to withstand the shock and vibration encountered by vehicle mounted equipment. The battery charger features: •...
Page 3
Automatic Current Limiting When batteries are severely discharged, some battery chargers can be overloaded due to the high charging current required. The Auto Charge 35/10 contains an automatic current limit. This circuit limits the output current to the rated 35 amperes when charging a deeply discharged battery or if the starter cranks the engine while charging.
Page 4
SINCE 1967, DESIGNERS OF INNOVATIVE PRODUCTS KUSSMAUL ELECTRONICS COMPANY, INC. 170 CHERRY AVENUE, WEST SAYVILLE, NEW YORK, 11796-1221 USA TEL. In NY: 631 567-0314...
Page 5
Remote Battery Charge Condition Indicator This remote indicator shows the charge condition of the battery in 10 levels from “LOW CHARGE” to “FULLY CHARGED”. This device indicates a defective battery when a bar graph does not rise to the “FULLY CHARGED” level after an extended period of charging.
Installation Wiring Diagram Auto Charge 35/10 BATTERY SAVER Indicator POWER A.C. FUSE OUTPUT BAT1 INPUT REMOTE Strip insulation 15/32 so that wire strands are To 120 volts A.C. flush with end of Bat te ry S aver L o ad s eyelet, 2 places, ( 1 0 a m p s...
Page 7
Specifications: Input: 120 volt, 50/60 Hz, 10 amperes Input Fuse: 12 ampere, fast acting Output: 12 volts D.C. 35 amperes Max. Remote Sensing: Electronic, sense wires not required Number of Charger Outputs: 1 Number of Battery Saver Outputs: 1 Battery Saver Output: 12 volts D.C., 10 amperes Max. Indicators: Power: Red LED, indicates 120 volts power applied Battery Saver Overload: Yellow LED, indicates Battery Saver...
Kussmaul Electronics Company, Inc. shall have no liability for dam- ages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The pur- chaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others.