Advertisement
Quick Links
AUTO CHARGE
1200 PUMP PLUS
AUTOMATIC BATTERY CHARGER
INPUT :115 volt, 60 Hz, 10 amps
KUSSMAUL ELECTRONICS CO., INC
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314
INSTRUCTION MANUAL
MODEL #091-9-1200
OUTPUT: 40 AMPERES
3 YEAR WARRANTY
TOLL FREE: 800-346-0857
FILE: 091-9-1200.P65
DATE: 11-1-2005
REV. C
.
FAX: 631-567-5826
Advertisement
Related Manuals for KUSSMAUL 091-9-1200
Summary of Contents for KUSSMAUL 091-9-1200
- Page 1 1200 PUMP PLUS AUTOMATIC BATTERY CHARGER MODEL #091-9-1200 INPUT :115 volt, 60 Hz, 10 amps OUTPUT: 40 AMPERES 3 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826...
- Page 2 INTRODUCTION The AUTO CHARGE 1200 PUMP PLUS is a compact, completely automatic, single channel battery charger designed for vehicles with a single battery system. The charger is ruggedized to withstand the shock and vibration encountered by vehicle mounted equipment. The AUTO CHARGE 1200 PUMP PLUS operates an 091-9 air compressor. With the selector switch in the AC position the compressor runs only when the AC power is applied.
- Page 3 Automatic Current Limiting When batteries are severely discharged, some batteries can be overloaded due to the high charging current required. The Auto Charge 1200 Pump Plus contains an automatic current limit. This circuit limits the output current to the rated 40 amperes when charging a deeply discharged battery or if the starter cranks the engine while charging.
-
Page 4: Installation Wiring Diagram
Installation Wiring Diagram NOTE INDICATOR WIRING PIN 1 OF INDICATOR MUST GO TO PIN 1 OF CHARGER, PIN 2 OF INDICATOR MUST GO TO PIN 2 OF CHARGER AND SO FORTH INDICATOR PLEASE CHECK CONNECTIONS AND COLOR OF WIRES BEFORE PLUGGING IN. AUTO CHARGE 1200 POWER REMOTE DISPLAY... -
Page 5: Indicator Installation
INDICATOR INSTALLATION 1. Locate Indicator in a convenient place on the vehicle. 2. Place the template in position and center punch in 4 places. 3. Drill holes as shown. 5. Cut out square hole. 6. Connect wiring to charger using butt connector supplied. 7. -
Page 6: Specifications
Specifications: Input: 115 volt, 60 Hz, 10 amperes Input Fuse : 15 ampere, fast acting Output: 12 volts D.C. 40 amperes Max. Remote Sensing: Electronic, sense wires not required Indicators: Power: Red LED, indicates 115 volts power applied Bar Graph: indicates charger output and state of charge of battery Weight: 21 lbs... -
Page 7: Warranty
Vehicle Identification Vehicle Owner WARRANTY All products of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped.