Pc Control Command; Cf_Fsync Command; Cf_Tdots Command; Cf_Clamp Command - Canon LV-5220 - Multimedia Projector SVGA Functional Specification

Expand Serial Command Functional Specification

8.5. PC Control Command

8.5.1. CF_FSYNC Command

Command "CF_FSYNC_%1" [CR]
"0000 – 0031" --------- Directly set Fine Sync setting value
%1 "UP" --------------------- Fine Sync setting value +1
"DN" --------------------- Fine Sync setting value -1
Set Fine Sync for PC signal. (When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable
Response
Unacceptable

8.5.2. CF_TDOTS Command

Command "CF_TDOTS_%1" [CR]
"nnnn – 9999" -------- Directly set Total Dots setting value
%1
"UP" --------------------- Total Dots setting value +1
"DN" --------------------- Total Dots setting value –1
Set Total Dots for PC signal. (When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable
Response
Unacceptable

8.5.3. CF_CLAMP Command

Command "CF_CLAMP_%1" [CR]
"0000 – 0127" --------- Directly set Clamp setting value
%1 "UP" --------------------- Clamp setting value +1
"DN" --------------------- Clamp setting value –1
Set Clamp PC signal. (When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable
Response
Unacceptable

8.5.4. CF_H-POS Command

Command "CF_H-POS_%1" [CR]
"0000 – nnnn" ------------ Directly set Horizontal Position setting value
%1
"UP" ------------------------- Horizontal Position setting value +1
"DN" ------------------------- Horizontal Position setting value –1
Set Horizontal Position PC signal.
(When it is in usual Power On state, this is valid)
Details The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable
Response
Unacceptable
"000" [CR]
"101" [CR] ---- Input is Video
"nnnn" is minimum value. This is current Display Dots
value＋Horizontal position value
"000" [CR]
"101" [CR] ---- Input is Video
"000" [CR]
"101" [CR] ---- Input is Video
"nnnn" is maximum value. This is current Total Dots
value - Display Dots value.
"000" [CR]
"101" [CR] ---- Input is Video
Page 15 of 41