Casio XJ-H2600 User Manual page 55

Problem
Text is blurry.
The message "Please input
the password." appears
and further operation is not
possible.
The remote controller does
not work.
The TEMP or LIGHT
indicator is flashing or lit.
The light source unit does
not light.
Important!
Try performing the following steps, which may or may not return the projector to normal
operation.
1. Unplug the AC power cord and wait for at least 10 minutes.
2. Plug the power cord back in and turn the projector back on again.
If normal operation does not resume after you perform the above steps, take the projector to
your retailer or authorized CASIO service center.
The image may be out of focus. Rotate the focus ring to focus.
The current frequency and/or phase setting do not match the input signal. (Applies
only when the input source is an RGB signal.) Press the [AUTO] key to execute an
automatic adjustment operation.
On the setup menu, perform the "Image Adjustment 2
Adjustment 2 Phase" adjustments. (Applies only when the input source is an
RGB signal.) See page 40.
If the input source is a video camera or document camera, check to make sure
there is no problem with the input source device.
The "Option Settings 1
setup menu is turned on, so the projector is password protected. Input the correct
password, and then press the [ENTER] key. See page 32.
The remote controller batteries may be dead. Replace the batteries.
The remote controller may be too far from the projector. Make sure the remote
controller is within the allowable range when you operate it. See page 56.
An error occurred. See "Error Indicators and Warning Messages" (page 51).
The light source unit has reached the end of its service life or it is malfunctioning.
Contact your original dealer or authorized CASIO service center for replacement.
Cause and Recommended Action
Password protection
55
Frequency" and "Image
Power On Password" setting on the