Valet Mode; Panic Mode - Directed Electronics Vehicle Security System 3901V Owner's Manual

Valet mode
®
You can prevent your system from arming, by using Valet
is very useful when washing the vehicle or having it serviced. In Valet
Mode, the system will not arm, even with the transmitter, but all con-
venience functions (door locks, trunk release, etc.) will work normally.
To enter or exit Valet® Mode with the integrated LED/Valet® switch:
steady if you have entered Valet
steps above. The LED will turn off when exiting Valet

Panic mode

(If programmed On, Step 3-2)
If you are threatened in or near your vehicle, you can attract attention
by triggering the system with your transmitter! If your factory keyless
transmitter does not have a panic button, this system can be pro-
grammed to enable a panic feature (refer to the Programming
Options).
If enabled, just press the lock button on your factory keyless transmit-
ter twice more than once within three seconds 7 seconds to enter Panic
Mode.
© 2007 Directed Electronics - all rights reserved
Turn the ignition to "on" position,
then turn to "off" position. Press
and release
LED/Valet switch within 10 sec-
®
onds. The status LED will light
® Mode. To exit Valet
the integrated
Mode. This
®
DRW-35
® Mode, repeat the
® Mode.
®
7