Specifications - Directed Audio 6550 Owner's Manual

SPECIFICATIONS

RMS continuous power per channel, Channels 1-4 driven
into 4 ohms from 20 to 20,000 Hz, with less than 0.08%
total Harmonic Distortion @ 14.4 VDC. Channel 5-6
driven into 4 ohms from 20-250 Hz, with less than
0.08% THD @ 14.4 VDC.
RMS continuous power per channel, Channels 1-4 driven
into 2 ohms from 20 to 20,000 Hz, with less than 0.1%
Total Harmonic Distortion @ 14.4 VDC. Channel 5-6
driven into 2 ohms from 20-250 Hz, with less than 0.1%
THD @ 14.4 VDC.
RMS continuous power, 3-channel operation, channels 1-
4 bridged into 4 ohms from 20 to 20,000 Hz, with less
than 0.1% Total Harmonic Distortion @ 14.4 VDC.
Channel 5-6 bridged into 4 ohms from 20-250 Hz, with
less than 0.1% THD @ 14.4 VDC.
Dynamic power rating (IHF-202 Standard) at minimum
load
Signal-to-Noise Ratio
Frequency Response
Damping Factor @ 4 ohm
Crossovers (ch 1-6)
Bass Equalization (Ch 5-6)
Input Impedance
Input Sensitivity
Output Impedance (ch 1-6)
Supply Voltage
Fusing and Power
Minimum Cable Requirements (AWG)
(Per amp, trunk mounted)
14
Directed model 6550 Ch 1-4 Ch 5-6
50 75
watts watts
75 125
watts watts
150 2 250
x
watts watts
700 watts
Greater than 95 dB
20-20,000 Hz ± 0.5 dB
Greater than 100
Switchable high or low pass
12 dB/octave, continuously
variable 50 to 500 Hz
Switchable 8dB,
centered at 40Hz
20K ohms
Variable from 150 mV to 8 volt
2 to 8 ohms, stereo
4 to 8 ohms, bridged
10 to 16 VDC
60A
#8
© 2002 Directed Electronics, Inc