Specifications - Directed Audio 500/2 Owner's Manual

SPECIFICATIONS

RMS continuous power per channel, both chan-
nels driven into 4 ohms from 20 to 20,000 Hz,
with less than 0.08% Total Harmonic Distortion
@ 14.4 VDC
RMS continuous power per channel, both chan-
nels driven into 2 ohms from 20 to 20,000 Hz,
with less than 0.1% Total Harmonic Distortion @
14.4 VDC
RMS continuous power bridged into a 4 ohm
load from 20 to 20,000 Hz, with less than 0.1%
Total Harmonic Distortion @ 14.4 VDC
Dynamic power rating (IHF-202 Standard)
bridged into 4 ohms
Signal-to-Noise Ratio
Frequency Response
Damping Factor @ 4 ohm
Crossover
Bass Equalization
Input Impedance
Input Sensitivity
volt
Output Impedance
Supply Voltage
Fusing and Power
Minimum Cable Requirements (AWG)
(Per amp, trunk mounted)
© 2003 Directed Electronics, Inc
Directed model
125 watts
200 watts
400 watts
550 watts
Greater than 95 dB
20-20,000 Hz ± 0.5 dB
Greater than 200
Switchable high or low pass
12 dB/octave, continuously
variable from 50 to 500 Hz
+8 dB, centered at 40Hz
20K ohms
Variable from 150 mV to 8
2 to 8 ohms, stereo
4 to 8 ohms, bridged
10 to 16 VDC
40A
#8
11