OneTouch ULTRAMINI Owner's Booklet page 9

Setting the time and date
®
Your OneTouch
pre-set. Before using your meter for the first time or if you change the meter battery, you
should check and update the time and date. Make sure you complete steps 1 to 6 below
to ensure your desired settings are saved.
æ
WARNING: If your display shows mmol/L rather than mg/dL, contact LifeScan Customer Service
at 1 800 227-8862. You cannot change the unit of measure. Use of the wrong unit of measure may
cause you to misinterpret your blood glucose level, and may lead to incorrect treatment.
Step 1
Turn the meter on, see page 3
After the test screen, the pre-set time and date will
appear on the display for five seconds.
The hour will now start flashing.
NOTE: If a setting does not need to be updated, simply wait five seconds. The meter
display will automatically advance to the next setting.
Step 2
Set the hour and "AM" or "PM"
With the hour flashing on the display, press and release ▲ or ▼ to go forward or backward
one hour. To move faster, hold the ▲ or ▼ buttons down. Note that "AM" or "PM" is linked
4
™
UltraMini Meter comes with the time, date and unit of measure