OneTouch ULTRAMINI Owner's Booklet page 35

Step 3
Match the code on the meter with the code on the test strip vial
If the code on the meter does not match the code on the test strip
vial, press ▲ or ▼ to match the code number on the test strip vial.
The new code number will flash on the display for three seconds,
and then stay constant for three seconds. The display will advance
to the screen with the flashing blood drop icon
If the codes already match, wait three seconds. The display will
advance to the screen with the flashing blood drop icon
Step 4
Mark the test as a control solution test
IMPORTANT:
• Mark all control solution tests with CtL. This will stop
them from being stored as blood glucose results.
• Control solution results marked with CtL are not stored
in the meter's memory.
Press ▲ so that the control solution test symbol CtL appears in the upper right corner of the
display. You must mark the test before you apply control solution. Once you have completed
the test, you cannot change the marking. The meter is now ready to perform a control
solution test.
30
R .
R
.