Configure Wpa/Wpa2 Personal - D-Link DIR-505 User Manual

Section 3 - Configuration
It is recommended to enable encryption on your wireless access
point before your wireless network adapters. Please establish wireless
connectivity before enabling encryption. Your wireless signal may
degrade when enabling encryption due to the added overhead.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the access point (192.168.0.50).
Click on Setup and then click Wireless Settings on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to WPA Mode, select Auto.(WPA.or.WPA2).
4. Next to Cipher Type, select TKIP, AES, or Auto.
5. Next to Passphrase, enter a key. The key is entered as a passphrase
in ASCII format at both ends of the wireless connection. The
passphrase must be between 8-63 characters.
7. Click Save.Settings at the top of the window to save your settings.
If you are configuring the access point with a wireless adapter, you
will lose connectivity until you enable WPA-PSK on your adapter
and enter the same passphrase as you did on the access point.
D-Link DIR-505 User Manual

Configure WPA/WPA2 Personal

128