Configure Wep - D-Link DIR-505 User Manual

Section 3 - Configuration

Configure WEP

It is recommended to enable encryption on your wireless router
before your wireless network adapters. Please establish wireless
connectivity before enabling encryption. Your wireless signal may
degrade when enabling encryption due to the added overhead.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the router (192.168.0.1).
Click on Wireless Setup on the left side.
2. In the Security Mode section, select WEP from the drop-down
menu.
3. In WEP Key Length, select either 64Bit or 128Bit encryption from
the drop-down menu.
5. Next to WEP Key 1, enter a WEP key that you create. Make sure
you enter this key exactly on all your wireless devices. You may
enter up to four different keys either using Hex or ASCII. Hex is
recommended (letters A-F and numbers 0-9 are valid). In ASCII all
numbers and letters are valid.
6. Click Save Settings to save your settings. If you are configuring the router with a wireless adapter, you will lose connectivity
until you enable WEP on your adapter and enter the same WEP key as you did on the router.
D-Link DIR-505 User Manual 109