Advertisement
Installing and Removing PCI Cards
Remove the card carrier by pulling up on the two blue release tabs. Use equal pressure and lift the card
Step 8
carrier out of the chassis.
With a screw driver, remove the screw from the desired slot cover.
Step 9
Remove the slot cover by pressing on it from inside the chassis.
Step 10
If the card is full length, use a screw driver to remove the blue thumb screw from the card support at the
back of the card carrier.
Carefully align the PCI card with the PCI-Express connector and alignment grooves for the appropriate
Step 11
slot. Apply firm even pressure until the card is fully seated in the connector.
Reinstall the slot cover screw to hold the card to the carrier. If necessary, reinstall the card support at the
Step 12
back of the card carrier.
Replace the card carrier in the chassis.
Step 13
Replace the chassis cover.
Step 14
Installing Cisco Intrusion Prevention System Appliances and Modules 5.1
6-20
!
!
!
!
Chapter 6
Installing IPS-4260
OL-8677-01
Advertisement
