Advertisement
Chapter 6
Installing IPS-4260
Initialize IPS-4260.
Step 9
For the procedure, see
Upgrade IPS-4260 with the most recent Cisco IPS software.
Step 10
For the procedure, see
You are now ready to configure intrusion prevention on IPS-4260.
For More Information
•
•
Removing and Replacing the Chassis Cover
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 120 VAC, 20 A U.S. (240 VAC, 16-20 A International).
Statement 1005
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement
1029
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Follow proper safety procedures when removing and replacing the chassis cover by reading the safety
Caution
warnings in
4200 Series Appliance
OL-8677-01
Initializing the Sensor, page
Obtaining Cisco IPS Software, page
For the procedure for using HTTPS to log in to IDM, refer to
For the procedures for configuring intrusion prevention on your sensor, refer to the following
documents:
Installing and Using Cisco Intrusion Prevention System Device Manager 5.1
–
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
–
5.1
Regulatory Compliance and Safety Information for the Cisco Intrusion Prevention System
Sensor.
10-2.
Installing Cisco Intrusion Prevention System Appliances and Modules 5.1
Removing and Replacing the Chassis Cover
11-1.
Logging In to
IDM.
6-17
Advertisement
