Advertisement
Chapter 6
Installing IPS-4260
Reinstall IPS-4260 on a rack, desktop, or table.
Step 10
If you are reinstalling in a rack, see
Power on IPS-4260.
Step 11
Installing and Removing PCI Cards
IPS-4260 has 6 expansion card slots, three full-height and three half-height slots. You can install the
optional network interface cards in the two top full-height slots, slots 2 and 3. IPS-4260 supports up to
two network interface cards. For an illustration of the expansion card slots, see
For an illustration of the supported PCI cards, see
We recommend that you install the 4GE bypass interface card in slot 2 if you are installing only one 4GE
Note
bypass card. This improves accessibility to the RJ45 cable connectors.
To install and remove PCI cards, follow these steps:
Log in to the CLI.
Step 1
Prepare IPS-4260 to be powered off:
Step 2
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
Note
Power off IPS-4260.
Step 3
Remove the power cord and other cables from IPS-4260.
Step 4
If rack-mounted, remove IPS-4260 from the rack.
Step 5
For the procedure, see
Step 6
Place IPS-4260 in an ESD-controlled environment.
For more information, see
Remove the chassis cover.
Step 7
For the procedure, see
OL-8677-01
You can also power down IPS-4260 using IDM. For the procedure, refer to
Appliance.
Rack Mounting, page
Working in an ESD Environment, page 1-25.
Removing and Replacing the Chassis Cover, page
Installing Cisco Intrusion Prevention System Appliances and Modules 5.1
Rack Mounting, page
6-9.
Supported PCI Cards, page
6-9.
Installing and Removing PCI Cards
Figure 6-5 on page
6-2.
Resetting the
6-17.
6-19
6-7.
Advertisement
