Cisco IPS-4260-K9 - IPS Sensor 4260 Installation Manual page 16

Installing IPS-4260
Connect the RJ-45 connector to the console port and connect the other end to the DB-9 or DB-25
Step 6
connector on your computer.
Attach the network cables.
Step 7
SPD indicator
"SPD"
IPS-4260 has the following interfaces:
GigabitEthernet0/1 (GE 0/1) is the sensing port.
•
Management0/0 (MGMT) is the command and control port.
•
GigabitEthernet2/0 through GigabitEthernet2/3 and GigabitEthernet3/0 through 3/3 are the
•
additional expansion port slots.
Caution Management and console ports are privileged administrative ports. Connecting them to an untrusted
network can create security concerns.
Power on IPS-4260.
Step 8
Installing Cisco Intrusion Prevention System Appliances and Modules 5.1
6-16
CONSOLE
Console
port (RJ-45)
RJ-45 to
DB-9 or DB-25
serial cable
(null-modem)
6
5
4
SPD LNK SPD LNK
CONSOLE GE 0/1 MGMT
Link/ACT indicator
"LINK"
MGMT
Computer serial port
SPD indicator
Diagnostic
indicators
(for TAC use)
Chapter 6 Installing IPS-4260
DB-9 or DB-25
Link/ACT indicator
System ID
indicator indicator
Status
OL-8677-01