Device Hardware Interfaces - NETGEAR GS724TPS - ProSafe - Gigabit Stackable PoE Smart Switch Hardware Installation Manual

GS700TPS Smart Switch
Table 3-2. System LEDs
LED
Power LED
FAN LED
MAX POE LED
1~48 Port LED mode select LED
Stack ID LED- One Seven
Segment LED Display
Stack Master LED
Stack Port LED

Device Hardware Interfaces

This section provides information for the following hardware interfaces:
• "RJ-45 Ports"
• "SFP GBIC Module"
• "Stacking Ports"
• "Factory Defaults Button"
Physical Description
Designation
• Off - Power is disconnected.
• Solid Green - Power is supplied to the switch and is operating
normally.
• Off - FAN is operating normally.
• Solid Yellow - FAN has failed.
• Off - Indicates that there is at least 8W of PoE power available for
another device.
• Solid Yellow - Indicates that less than 8W of PoE power is available.
• Flashing Yellow - Indicates the PoE MAX LED was active in the
• previous two minutes.
• Solid Green - LED Mode in Ethernet LED Mode (default).
• Solid Yellow - LED Mode in PoE LED Mode.
• Green - Displays Stack ID (1-6).
• Off - Switch acts as a slave member in a stack of switches.
• Solid Green - Switch acts as a master unit in a stack of switches. The
Stack Master LED is lit if there is an active stack link, and the unit is in
stack mode.
Indicates the Up/Down stacking port LED designations
• Off – Indicates the Up/Down stacking port link is down.
• Solid Green – Indicates the Up/Down stacking port link.
• Flashing Green – Packet transmission or reception is occurring on
the Up/Down stacking port.
v1.0, April 2009
3-5