Installation Procedures - Cisco 15454-TCC - Network Processor Card Operation Manual

Installation Procedures

Installation Procedures
Use this section if you are installing or removing the TCC-I card for the first time. After you become
familiar with ONS 15454 SDH card installation and boot up, use this section as a reference.
Caution Always use the supplied electrostatic discharge (ESD) wristband when working with an ONS 15454
SDH. Plug the wristband cable into the ESD jack located on the lower right outside edge of the shelf
assembly and ensure the shelf assembly is properly grounded.
Hazardous voltage or energy may be present on the backplane when the system is operating. Use caution
Caution
when servicing.
Open the card ejectors.
Step 1
Carefully insert the card into the guide rails of the desired slot
Step 2
has to be inserted into slot 7 or slot 11.
Push the card into the connector on the back plane by closing the ejectors.
Step 3
Figure 3
Installing ONS 15454 SDH TCC-I Cards
6
Installing cards in an ONS 15454 SDH
F A N
F A IL
C R
IT
M A
J
M IN
Guide rail
Ejector
(Figure 3 on page 6). The TCC-I card
78-14610-01