Cisco 15454-TCC - Network Processor Card Operation Manual page 8

Removal Procedures
To determine whether the TCC-I card is in active mode or standby mode, view it in the CTC software
Note
and position the cursor over the TCC-I card graphic to display the status.
If you need to perform a card pull on an active TCC-I card, initiate a software reset on the active TCC-I
Step 1
card first. (See the
When the TCC-I is in standby mode, unlatch the top and bottom ejector levers on the TCC-I card.
Step 2
Carefully remove the card from the shelf.
Step 3
Initiate a Software Reset
Step 1 Log into the CTC software.
Right-click the TCC-I card to reveal a pull-down menu.
Step 2
Click Reset Card. (See
Step 3
Figure 4
Click Yes in the dialog box when the "Are You Sure?" prompt appears.
Step 4
Click OK in the dialog box when the "Lost connection to node, changing to Network View" prompt
Step 5
appears.
Confirm that the TCC-I card is in standby mode after the reset.
Step 6
Installing ONS 15454 SDH TCC-I Cards
8
"Initiate a Software Reset" section on page
Figure 4).
Resetting from the TCC-I card pull-down menu
8).
78-14610-01