Filter Cycle Start Time; Filter Cycle Duration; Number Of Filter Cycles; Pump Run Time - Dimension One Spas Sarena Bay Owner's Manual

Button in the same manner as the hour number. When the desired number is displayed, push the LIGHT
Button to accept the selection and change the flashing number to a flashing AM or PM indicator. Adjust the
indicator with the UP or DOWN Buttons. After reaching the correct time, push the PROGRAM Button
to set the time and exit the time setting mode. You will then be prompted to set the filter start time.

Filter Cycle Start Time

After setting the time-of-day, the top line of the Digital Display Window will read "SET FILTER CYCLE
TIME". Push the UP or DOWN Buttons in the same manner as setting the clock to select the time you
want your filter cycle to start. When your desired filter cycle start time is set in the display, push the
PROGRAM Button to continue. The pre-set factory default is 12:00 p.m. to 1:00 p.m. repeating every 12 hours
unless the number of filter cycles per day has been changed.
Keep in mind that you will later be prompted to set the filter cycle duration and the number of
filter cycles. Be sure to keep this in mind when programming your filter cycle start time.
Note
During a filter cycle, the bottom left of the Digital Display Window will read "SPA FILTERING". During the
filter cycle, JETS 1 will activate, the first 5 minutes at high speed and the remainder of the filter cycle time at
low speed. JETS 2 will also activate for 1 minute on high speed and then turn off.

Filter Cycle Duration

After setting the filter cycle start time, the top line of the Digital Display Window will read "SET CYCLE
DURATION". Push the UP or DOWN Buttons to toggle between 10, 20, 30, 40, 50, or 60 minutes. The
filter cycle will be at low speed. When your desired filter cycle length appears in the Digital Display Window,
push the PROGRAM Button to select it. The pre-set factory default is 20 minutes.

Number of Filter Cycles

After setting the length of the filter cycle, you will be prompted to set the number of filter cycles. The top line
of the Digital Display Window will read "SET # OF CYCLES". Push the UP or DOWN Button to toggle
between 1, 2, 3, or 4 cycles per day. When your desired number of cycles appears on the Digital Display
Window, push the PROGRAM Button to select it. The pre-set factory default is 1 cycles per day.
Long and/or numerous filter cycles could cause overheating of the hot tub - especially in hot
climates.
Caution

Pump Run Time

After setting the number of filter cycles, the top line of the Digital Display Window will read "SET PUMP
RUN TIME". Push the UP or DOWN Button to toggle between 30, 45 and 60 minutes. This sets the
length of time the pump will run when a jets Button is pushed. For example, if you choose 45 minutes, when
you push a jets Button, the pump will run for 45 minutes before shutting down automatically. When your
desired pump run time appears on the Digital Display Window push the PROGRAM Button to select it. The
pre-set factory default is 30 minutes.
2003 Sarena Bay™
Export Owner's Manual
29