Kurzweil PC2 - MUSICIANS GUIDE REV A Manual page 22

Startup
Powering Up
No Sound from Receiving Instrument
If you are trying to control another instrument using MIDI and that instrument doesnÕt respond
to your PC2, check the following:
¥ A working MIDI cable should connect the PC2Õs Out or Thru/Out jack to the In jack of the
other instrument
¥ If youÕre using the MIDI Thru/Out port, ßip the switch near the MIDI In port to the out
position (a ball-point pen works well for this)
¥ Continuous control pedal 1: check the connection and pedal position
¥ The other instrument should be receiving on the same MIDI channel that the PC2 is using to
transmit MIDI information
¥ All zones that you want to transmit must be active (the lights in the Zone 1ÐZone 4 buttons
must be green)
¥ The PC2 might be sending MIDI information only to itself: press the MIDI Xmit button in
the Zone Parameters region of the front panel, then press the right-arrow button under the
display once, then turn the large knob in the Data Entry region until you see
Local+MIDI
2-8
or
MIDI