Kurzweil PC2 - MUSICIANS GUIDE REV A Manual page 111

Clock
Set Clock to Internal (the default) to use the PC2Õs internal MIDI clock for arpeggiation, and to
control synchronization with external MIDI equipment. Set Clock to External when you want
the PC2 (including the arpeggiator) to synchronize with a MIDI Clock signal from an external
source.
Transmit Clock
This parameter determines whether the PC2 sends its internal MIDI clock signal to its MIDI Out
port. This parameter is irrelevant if the Clock parameter has a value of External. There are three
possible values:
The PC2 doesnÕt transmit its internal clock signal.
Off
The PC2 always transmits its internal clock signal to its MIDI Out port.
On
Default value. The PC2 transmits its internal clock signal to its MIDI Out port only
Seq
when youÕre playing one of the demo sequences or using the arpeggiator.
Touch
Sets the keyboard sensitivity for the entire PC2, somewhat like the Vel Scale parameter for
individual programs and setups (like Vel Scale, the value for the Touch parameter also affects
notes that get sent via MIDI). There are seven possible values:
1 Linear
2 Light1
3 Light2
4 Light3
A value of Linear (the default) is the standard, unaltered level of keyboard sensitivity. Values of
Light1ÐLight3 are for players who have a light touchÑthat is, you can play more lightly and
still get the same attack-velocity values. Light1 is more sensitive than Linear, and Light3 is the
most sensitive.
Values of Hard1ÐHard3 are for players who have a heavier touchÑthat is, you can play harder
and still get the same attack-velocity values. Hard1 is less sensitive than Linear, and Hard3 is the
least sensitive.
Change Setups (Chg Setups)
Determines what the PC2 does when you select a setup.
Immediate
The newly-selected setup becomes active as soon as you select it. Any notes being held by the
PC2 (or by Kurzweil instruments receiving MIDI from the PC2) continue with their normal
decays. Non-Kurzweil MIDI slaves may cut off notes as soon as the PC2Õs setup changes.
Keys Up
Default value. The newly-selected setup becomes active only after youÕve physically released all
keys (notes held with Sustain or other MIDI Controllers donÕt delay the change). Until you
5 Hard1
6 Hard2
7 Hard3
Descriptions of Parameters
System Parameters
5-31