Kurzweil PC2 - MUSICIANS GUIDE REV A Manual page 106

Descriptions of Parameters
Effects Editor Parameters
changes as well as those received via MIDI. All other programs use the current effect, but retain
their own settings for wet/dry mix.
FX Chg Mod is Panel
In this case, the value of FX Channel is irrelevant. Program changesÑeither from the PC2 or via
an external MIDI sourceÑnever change the current effect (you must change the current effect
from the PX2Õs front panel). The channel used by the program in the display adopts the wet/dry
mix of the current effect as soon you change the effect via the front panel. The other channels
donÕt adopt the wet/dry mix of the current effect until you make a program change.
MIDI Receive Mode
When youÕre in MIDI Recv mode (that is, when youÕre in the MIDI Recv menu), program
changes received via an external MIDI source change the current effect (or not) according to the
same rules describe above. The only difference is that when the PC2 receives a program change
via MIDI, the wet/dry mix settings for each channel are determined by the wet/dry parameters
in the MIDI Recv menu.
Stored Effects (Stored FX)
The value of this parameter is relevant only for those factory programs and setups to which
youÕve stored effects settings. For these programs and setups, you can quickly revert to using
the factory effect settings without erasing your user-deÞned settings (which is what happens
when you use one of the Restore Factory Effects functions in any Save dialog). This parameter
has two possible values:
Factory
When you select a program or setup, the PC2 applies the original factory settings to the
corresponding effect, even if you have stored your own effect settings with the program or setup
User
When you select a program or setup, the PC2 applies your user-deÞned settings (if any) to the
corresponding effect.
If you change the value of this parameter, youÕll need to reselect the current program to notice
the change in effect. This parameter works only when the value of FX Chg Mode is Auto. When
FX Chg Mode is Panel, the PC2 uses the factory settings for whatever effect you select from the
front panel.
5-26