Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 6 Manual page 56

Program Mode and the Program Editor
The AMP Page
Note Attack
Controls the attack characteristic of notes. Normal provides a smoothed attack, while a setting
of Hard has an instant attack and will produce an audible click, in addition to any amount of
key click speciÞed with the other parameters on this page (you might prefer not to specify any
additional key click when you use this setting). PercHard sets a hard attack level for percussion
only; notes without percussion use a normal attack.
Note Release
Controls the release characteristic of notes. A setting of Normal has a smoothed release, while a
setting of Hard has an instant release. Hard will produce an audible click.
The AMP Page
Assign amplitude controllers on this page, which is similar to the F4 AMP page for VAST
programs (see page 6-28 for a full description. The only difference between the AMP pages for
KB3 programs and VAST programs is that the KB3 version doesnÕt have the KeyTrk, VelTrk, and
Pad parameters.
EditProg:AMP||||||||||||||||||||||||||||
Adjust:0dB||||||||||Src1||:OFF||||||||||
||||||||||||||||||||Depth|:0dB||||||||||
||||||||||||||||||||Src2||:OFF||||||||||
||||||||||||||||||||DptCtl:MWheel|||||||
||||||||||||||||||||MinDpt:0dB||||||||||
||||||||||||||||||||MaxDpt:0dB||||||||||
<more||PERC|||PERC2||KEYCLK|AMP||||more>
The OUTPUT Page
Use this page to route the programs signal from the sound engine to KDFX. This page is similar
to the VAST-program version; the only difference is that it doesnÕt have the CrossFade and
XFadeSense parameters. See page 6-29 for a description of the OUTPUT-page parameters.
EditProg:OUTPUT|||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Pair:KDFX-A|||||||||||||||||||||||||||||
Pan|:L|||||||*|||||||R||||||||||||||||||
Mode:+MIDI||||||||||||||||||||||||||||||
Gain:18dB|||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
<more||OUTPUT||||||||MISC|||EQ|||||more>
6-56