Table of Contents
Advertisement
Installing the main unit
Installing the main unit
- Installation angle -
Tip
To maintain proper function, the unit must be
mounted at less than 30 degrees. If the angle is in
excess of 30 degrees, CD skipping or ejection may
occur.
- Main unit installation example (If installing the main unit using the mounting sleeve) -
Tip
• Carefully bind any excess length of cord that is
connected to the main unit and secure it to an
area of empty space in the vehicle so that it does
not move around or get caught in the main unit or
vehicle-side equipment. If the cords are not
handled correctly, operating problems or short-
circuits may occur, and this may result in the
danger of fire or other accidents.
• Connect all cables before installing the main
unit.
1
Insert the mounting sleeve into the opening in the
vehicle dashboard or console box.
2
Use a screwdriver or the like to bend the tabs in
the mounting sleeve to secure the mounting
sleeve.
3
Attach the side brackets to the main unit using
flathead screws.
Tip
Be sure to use the supplied accessory mounting
screws (Red:M5 x 8) as the mounting screws. If
any other screws are used, they may damage the
inside of the unit.
4
Mount the stud bolt to the main unit.
5
Insert the main unit into the mounting sleeve until
it locks in place.
6
Fasten the rear of the main unit.
7
Install the bezel on the main unit.
Tip
• Be careful not to forcefully push on the main unit's
display or buttons during installation. This may
result in damage to the main unit.
• This installation method is only one example.
When installing the main unit to the vehicle, be
sure to as the place of purchase for information
on what installation method to use.
Dashboard or console box
3
Mounting sleeve
Metal of vehicle
Dashboard or console box
5
- 7 -
Front
30˚ or less
Level (reference)
Bend the mounting
tabs.
Main unit
1
7
Flat head
screws
(Red:M5 x 8)
x 2
4
Side brackets
9
Bushing
8
Stud bolt
3
Mounting sleeve
Bezel
Advertisement
Table of Contents
