Table of Contents
Advertisement
- Main unit installation example (If installing the main unit using the side brackets of the vehicle) -
Tip
• Carefully bind any excess length of cord that is
connected to the main unit and secure it to an
area of empty space in the vehicle so that it does
not move around or get caught in the main unit or
vehicle-side equipment. If the cords are not
handled correctly, operating problems or short-
circuits may occur, and this may result in the
danger of fire or other accidents.
• Connect all cables before installing the main
unit.
1
Remove the pocket and any other accessories
from the centre cluster to make room for the main
unit.
2
Remove the mounting brackets for the pocket.
3
Attach the brackets to the main unit.
Tip
Be sure to use the supplied accessory mounting
screws (Red:M5 x 8) as the mounting screws. If
any other screws are used, they may damage the
inside of the unit.
4
Install the main unit in the vehicle.
Tip
• Be careful not to forcefully push on the main unit's
display or buttons during installation. This may
result in damage to the main unit.
• This installation method is only one example.
When installing the main unit to the vehicle, be
sure to as the place of purchase for information
on what installation method to use.
Centre cluster panel
Pocket, etc
Mounting bolts
Pocket
Hex-head bolt
6
(Red:M5 x 8) x 4
Select the screws in accordance with the shapes
of the screw holes in the mounting bracket.
- 8 -
Main unit
1
Hex-head bolt
6
(Red:M5 x 8) x 4
Screw
x 4
Mounting bracket
Flat head
7
screw
(Red:M5x8) x 4
Advertisement
Table of Contents
