Troubleshooting - Bissell HEALTHY HOME PROHEAT User Manual

T
roubleshooting
Heat indicator light does not illuminate
Possible Causes
1. The heater switch is not turned on.
2. The machine power switch is not turned on.
Reduced spray OR no spray
Possible cause
1. Bladder may be empty.
2. 2-in-1 water tank may not be seated properly.
3. P ump may have lost prime.
4. The pump belt may be broken.
16
w w w . b i s s e l l . c o m
A.
B.
Slots Pump Belt
WARNING:
To reduce the risk of electric
shock, or injury, unplug from the
outlet before servcing
Remedies
1. Turn on the heater switch located on side of unit.
2. Both switches must be on to activate the heat
indicator light.
Remedies
1. Turn power switch off; refill bladder with clean hand hot tap
water and formula.
2. Turn power switch off; remove tank and reseat.
3. Turn power switch off; after 1 minute turn on and depress
spray trigger.
4. Turn power switch off and unplug from the outlet. To check
if a pump belt has broken, you will need a flat head
screwdriver. A. Insert the blade end into the slot of the
belt access door to release. Examine the belt for breakage.
You should be able to see the pump belt looped around
the motor shaft. If it is broken or missing, please refer to
Replacement Parts on page 18. A replacement belt may be
ordered by calling BISSELL Consumer Services Complete
installation instructions will accompany the replacement belt.
B. When replacing belt access door be sure to line up slots of
belt access door with slots in machine, slide door into place and
snap shut.