Kyocera KM-1650 Operation Manual page 136

Address Editor
In [Network 1] tab
10. DNS Server (Sec.) ......... Type the IP address of the secondary DNS server in this field in the following
11. DNS Domain Name ....... Type the domain name (up to 32 single-byte characters) in this field.
1. Network 1/ Network 2 /
IP-Filters Tabs ................ Click on the desired tab to switch between network 1, network 2 and IP Filters
2. Host Name ..................... Type the host name of the scanner (up to 32 single-byte characters) in this
3. IP Address ..................... Type the IP address of the Scanner Interface Card in this field in the following
4. Subnet Mask .................. Type the subnet mask of the Scanner Interface Card in this field in the
5. Default Gateway ............ Type the default gateway of the Scanner Interface Card in this field in the
6. DHCP/BOOTP ................ The DHCP and BOOTP can be set to either "ON" or "OFF". The factory
7. RARP .............................. The RARP can be set to either "ON" or "OFF". The factory default setting is
8. ARP/PING ...................... The ARP/PING can be set to either "ON" or "OFF". The factory default setting
9. DNS Server (Pri.) ........... When a host name is used for transmitting data under an environment that
settings.
field.
form: XXX.XXX.XXX.XXX Whenever you attempt to change the IP address, a
confirmation dialogue box will appear in which you will need to verify that you
really want to change the address.
following form: XXX.XXX.XXX.XXX
following form: XXX.XXX.XXX.XXX
* This is used for transmitting packets to another network or subnet.
default setting is "ON".
"ON".
is "ON".
uses a DNS server, type the IP address of the primary DNS server in this field
in the following form: XXX.XXX.XXX.XXX
form: XXX.XXX.XXX.XXX
Page 3-40