Using Cisco Configuration Professional Express; Using The Cisco Cli-Manual Configuration - Cisco WS-C1924-A - Catalyst 1900 24 Ports 10MB Switch Hardware Installation Manual

Performing the Initial Configuration on the Router
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
%LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
%LINK-3-UPDOWN: Interface Ethernet0/1, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0/0, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0/1, changed state to down
%LINK-3-UPDOWN: Interface Serial0/2, changed state to down
%LINK-3-UPDOWN: Interface Serial1/0, changed state to up
%LINK-3-UPDOWN: Interface Serial1/1, changed state to down
%LINK-3-UPDOWN: Interface Serial1/2, changed state to down
<Additional messages omitted.>
When the messages stop appearing on your screen, press Return to get the
Step 13
Note
The
Step 14
configuration. Nevertheless, this is not a complete configuration. At this point, you have two choices:
•
•

Using Cisco Configuration Professional Express

Use the Cisco Configuration Professional Express web-based application to configure the initial router
settings. See
For help with interface and port numbering, see the
Using the Cisco CLI—Manual Configuration
This section shows you how to access the CLI to perform the initial configuration on the router.
If the
Note
ROM monitor, see
Cisco 1900 Series Hardware Installation
5-6
If you see the following message, it means that no other routers were found on the network
attached to the port:
%AT-6-ONLYROUTER: Ethernet0/0: AppleTalk port enabled; no neighbors found
prompt indicates that you are now at the CLI and you have just completed the initial router
Router>
Run the setup command facility again, and create another configuration.
Router> enable
Password: password
Router# setup
Modify the existing configuration or configure additional features by using the CLI:
Router> enable
Password: password
Router# configure terminal
Router(config)#
Cisco Configuration Professional Express User Guide
prompt appears, your system has booted in ROM monitor mode. For information on the
rommon 1>
Using the ROM
"Interface Numbering" section on page
Monitor.
Chapter 5 Configuring the Router
prompt.
Router>
for detailed instructions.
1-13.
OL-19084-02