Configuring Gigabit Ethernet Interfaces - Cisco WS-C1924-A - Catalyst 1900 24 Ports 10MB Switch Hardware Installation Manual

Performing the Initial Configuration on the Router
line console
exec-timeout 2 30
The following example shows how to set the console idle privileged EXEC timeout to 10 seconds:
line console
exec-timeout 0 10

Configuring Gigabit Ethernet Interfaces

This sections shows how to assign an IP address and interface description to an Ethernet interface on
your router.
For comprehensive configuration information on Gigabit Ethernet interfaces, see the "Configuring LAN
Interfaces" chapter of the
For information on interface numbering, see the software configuration guide for your router.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
show ip interface brief
Example:
Router# show ip interface brief
Step 3
configure terminal
Example:
Router# configure terminal
Cisco 1900 Series Hardware Installation
5-12
Cisco IOS Interface and Hardware Component Configuration
enable
show ip interface brief
configure terminal
interface {fastethernet | gigabitethernet} 0/port
description string
ip address ip-address mask
no shutdown
end
show ip interface brief
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Displays a brief status of the interfaces that are configured
for IP.
Learn which type of Ethernet interface is on your
•
router.
Enters global configuration mode.
Chapter 5 Configuring the Router
Guide.
OL-19084-02