Command: Snmp-Server Community - Dell PowerConnect 2816 User Manual

show interfaces counters
show users
show sessions
show logging file
show logging
If you specify the memory keyword, the show tech-support command displays the output:
flash info (dir if existed, or flash mapping)
buffers info (like print os buff)
memory info (like print os mem)
proc info (like print os tasks)

Command: snmp-server community

Use the snmp-server community command to set up the community access string to permit access to
the Simple Network Management Protocol command. Use the no form of this command removes the
specified community string.
snmp-server community
no snmp-server community
Syntax Description
community
• — Community string that acts like a password and permits access to the SNMP protocol.
• ro — Specifies read-only access (Default)
• rw — Specifies read-write access
• su — Specifies SNMP administrator access
ipv4-address
• — Management station IPv4 address. Default is all IP addresses.
Parameters range
community
• — 1 - 20 chars
ip-address
• — Valid IP address
Default
No community is defined
Command Mode
Global configuration
community
[ro | rw | su] [
community ipv4-address
[
ipv4-address
]
]
Dell PowerConnect 28xx Systems User Guide
171