To Advance From One Channel To Another; To Exit Learn Routine; Transmitter Configuration; Standard Configuration - DEI Rattler 100 Installation Manual

4.

to advance from one channel to another

You can advance from one channel to another by releasing the Valet
channels and then holding it. For instance: You have programmed Channel 1 and you want to program Channel
2. Release the Valet
Now, press and HOLD the Valet/Program switch down and the unit will chirp twice. As before, do not release it.
If you want to program Channel 3 after programming Channel 1, release the Valet/Program switch, press it twice
and then release it to advance to Channel 3. Then press the Valet/Program switch once more and HOLD it. The
horn will honk three times to confirm it is ready to receive the code from the transmitter to program Channel 3.

to exit learn routine

The learn routine will be exited if:
The ignition is turned off.
The Valet/Program switch is pressed too many times.
More than 15 seconds elapses between steps.
One long horn honk (if connected) indicates that the Learn Routine has been exited.

transmitter configuration

The transmitters can be programmed with the Standard Configuration by using the Channel 4 Auto Learn Standard
Configuration function in the Transmitter/Receiver Learn Routine. When programmed for Standard Configuration,
the transmitter buttons are assigned to the following functions:
Button I................................................operates ........................................Arm/Panic
Button II ..............................................operates ........................................Disarm/Channel Two
Buttons I and II.....................................operate..........................................Channel Three
NOTE: If using an optional four-button remote, the Standard Configuration may alternately
be taught to Buttons III and IV by pressing Button III in Step 3 of the Transmitter/Receiver
Learn Routine.
22
Release. Once the code is learned, the Valet/Program switch can be released.
® /Program switch. Press it one time and release it to advance from Channel 1 to Channel 2.
® /Program switch and tapping it to advance
© 2000 Directed Electronics, Inc. Vista, CA