Activating The Forward Events To Another Sentinel System Rule; Configuring Sentinel Link Integrator Settings - Novell SENTINEL LOG MANAGER 1.0.0.5 - ADMINISTRATION GUIDE 03-31-2010 Administration Manual

7.4.1 Activating the Forward Events To Another Sentinel
System Rule
The Forward Events To Another Sentinel System rule is installed with Log Manager, but it is in the
inactive (off) state. To forward the system events to another Sentinel system, the rule must be
activated, and the Sentinel Link Integrator settings must be configured.
1 Log in to the Sentinel Log Manager as an administrator.
2 Click rules in the upper left corner of the page.
3 The Rules tab is displayed on the right pane of the page.
The Forward Events To Another Sentinel System rule is displayed under the Rules tab.
4 To activate the Forward Events To Another Sentinel System rule, click the check box next to
the rule.
If the rule is activated, a

7.4.2 Configuring Sentinel Link Integrator Settings

In addition to activating the Forward Events To Another Sentinel System rule, you must also
configure the Sentinel Link Integrator settings.
Configuring the Send to Sentinel Link settings is same as configuring the Sentinel Link Integrator
settings. The Send to Sentinel Link settings configures the Sentinel Link Integrator instance that is
pre-installed on Sentinel Log Manager.
To configure the Send to Sentinel Link settings, refer to
page 119.
128 Sentinel Log Manager 1.0.0.4 Administration Guide
Successfully activated the rule
message is displayed.
"Sending the Events to a Sentinel Link" on