What's Next; Testing Your Data Synchronizer System; Uninstalling The Mobility Pack - Novell DATA SYNCHRONIZER MOBILITY PACK - INSTALLATION GUIDE 07-2010 Installation Manual

E-mail messages received after initial synchronization of the mobile device. For convenience,
you can send users a welcome message after their devices have synchronized, so that users can
see that they are receiving e-mail. If users want to receive existing e-mail messages on their
devices, they can mark the messages Unread in GroupWise to force the existing messages to
synchronize to their mobile devices.
Folders in the Cabinet (but not items in folders until users request them by opening folders)
In Synchronizer Web Admin, you can monitor the progress of data synchronization from
GroupWise to the Mobility Connector, as described in
Synchronization Status" in
Connector Installation and Configuration
IMPORTANT: If you selected Block Incoming Devices during Mobility Pack installation, you must
unblock incoming devices in Synchronizer Web Admin after all GroupWise data has synchronized
to the Mobility Connector. Follow the instructions in
"Mobility Connector Configuration" in the
Guide.
Users must configure their mobile devices to connect to your Synchronizer system. For information
about general device configuration, initial device synchronization, and ongoing synchronization, see
the Mobility Connector Quick Start on the
(http://www.novell.com/documentation/datasync_connectors1).
For device-specific information, see the
wiki.novell.com/index.php/Data_Synchronizer_Mobility_Connector).

2.2.6 Testing Your Data Synchronizer System

1 Test your Synchronizer system by logging into the GroupWise client and sending yourself an
e-mail message
2 Reply to the message from your mobile device.
If the message synchronizes to your mobile device and the reply on your mobile device
synchronizes back to GroupWise, your basic Synchronizer system is up and running.
3 To customize and expand your Synchronizer system, see
page 31.

2.2.7 Uninstalling the Mobility Pack

IMPORTANT: When you uninstall the Data Synchronizer software, certificate files are also
deleted. If you have obtained commercially signed certificates for use in your Synchronizer system,
back them up before uninstall the Data Synchronizer software.
1 In a terminal window on the Synchronizer server, become
password.
2 Change to the following directory:
/opt/novell/datasync
3 Run the Synchronizer Uninstallation script:
./ds_uninstall.sh
"Synchronization Monitoring and
Guide.
Mobility Connector Installation and Configuration
Novell Data Synchronizer Documentation Web site
Novell Data Synchronizer Mobility Connector Wiki (http://
"Monitoring Mobility Connector
Management" in the
"Blocking/Unblocking Incoming
Chapter 3, "What's Next," on
by entering
root
Mobility
Devices" in
and the
su - root
Mobility Pack Installation 29