Checking The Status Of The Data Synchronizer Services - Novell DATA SYNCHRONIZER MOBILITY PACK - INSTALLATION GUIDE 07-2010 Installation Manual

Secure
Generate Self-Signed Certificate
Enter Certificate File
Block Incoming Devices
GroupWise Address Book User
Add Users and Groups:
Users
Groups
14 On the Mobility Pack Configuration page, click Next to save the configuration settings and set
up your Synchronizer system.
You see the Data Synchronizer Mobility Pack listed on the Installed Add-on Products page.
15 Click OK to return to the main YaST page.
If you encounter any problems during the installation, check the Mobility Pack Installation program
log file for information about the problem:
/var/log/datasync/mobilityPackInstall.log
The Mobility Pack Installation program creates the following directories and files:
/opt/novell/datasync
/etc/datasync
/etc/init.d/datasync*
/usr/sbin/rcdatasync*
/var/lib/datasync
/var/log/datasync
/var/run/datasync

2.2.3 Checking the Status of the Data Synchronizer Services

The Mobility Pack Installation program should start the Synchronizer services for you.
1 Open a terminal window, then log in as
2 Check the status of the Synchronizer services:
rcdatasync status
If the installation proceeded normally, the four Synchronizer services should be running.
Use the following commands as
rcdatasync start
rcdatasync restart
rcdatasync stop
The Synchronizer services can also be managed independently, as described in
Synchronizer Services" in the
.
root
to manually start and stop all the Synchronizer services:
root
Novell Data Synchronizer Administration
"Managing the
Guide.
Mobility Pack Installation 27