Checking The Status Of The Data Synchronizer Services; Checking The Status Of The Groupwise Connector - Novell DATA SYNCHRONIZER - INSTALLATION GUIDE 07-2010 Installation Manual

/opt/novell/datasync
/etc/datasync
/etc/init.d/datasync*
/usr/sbin/rcdatasync*
/var/lib/datasync
/var/log/datasync
/var/run/datasync

2.2.3 Checking the Status of the Data Synchronizer Services

The Data Synchronizer Installation program should start the Synchronizer services for you.
1 Open a terminal window, then log in as
2 Check the status of the Synchronizer services:
rcdatasync status
If the installation proceeded normally, the four Synchronizer services should be running.
Use the following commands as
rcdatasync start
rcdatasync restart
rcdatasync stop
The Synchronizer services can also be managed independently, as described in
Synchronizer

2.2.4 Checking the Status of the GroupWise Connector

The Data Synchronizer Installation program starts the GroupWise Connector for you. Use
Synchronizer Web Admin to check connector status.
1 In a Web browser, display Synchronizer Web Admin:
https://data_synchronizer_server:8120
Replace
where you installed the Data Synchronizer system.
2 Log in as the Synchronizer administrator that you set up during installation.
If the installation proceeded normally, the GroupWise Connector should be running.
24 Novell Data Synchronizer Installation Guide
root
Services" in the Novell Data Synchronizer Administration
data_synchronizer_server
.
root
to manually start and stop all the Synchronizer services:
with the IP address or DNS hostname of the server
"Managing the
Guide.