Novell BUSINESS CONTINUITY CLUSTERING 1.1 SP1 - 9-21-2010 ADMINISTRATION GUIDE FOR OPEN ENTERPRISE SERVER 1 SP2 LINUX Administration Manual page 28

/tmp/bcc_install
5 Enter a host wildcard if desired, click OK, then click Finish.
Installing and Configuring Business Continuity Clustering on Each Cluster Node
1 Create a new YaST software installation source by opening a shell and running
inst_source
2 Add nfs as the source type.
3 Specify the server and directory you entered in
4 Install Business Continuity Clustering software by opening a shell and running the following
commands in the order indicated:
yast2 sw_single -i \
novell-business-continuity-cluster \
novell-cluster-services-cli \
yast2-bcc
5 Autoconfigure Business Continuity Clustering software by running the following command
from a shell:
yast2 bcc_autoconfig path_to_XML_profile
Replace path_to_XML_profile with the path to the file you created in
6 Remove the installation source you created in
6a Open a shell and run
6b Select the Business Continuity Clustering installation source, click Delete, then click
Finish.
Removing the NFS Share from Your Server
1 Open a shell and run
2 Select Start Server, then click Next.
3 Select the Business Continuity Clustering installation directory, click Delete, then click Finish.
Cleaning Up the Business Continuity Clustering Installation Source
Clean up the Business Continuity Clustering installation source by opening a shell and running one
of the commands below, depending on which method you chose in
rm -rf /tmp/bcc_install
or
unmount /mnt/iso
28 Novell Business Continuity Clustering 1.1 Administration Guide for Linux
.
yast2 inst_source
yast2 nfs_server
Step 4 on page 27, click OK, then Finish.
Step 1 on page
Step 1 above by completing the following steps:
.
Step 1 on page
yast2
26.
27.