Business Continuity Cluster Component Locations - Novell BUSINESS CONTINUITY CLUSTERING 1.1 SP1 - 9-21-2010 ADMINISTRATION GUIDE FOR OPEN ENTERPRISE SERVER 1 SP2 LINUX Administration Manual

IMPORTANT: Before you begin, make sure your setup meets the requirements specified in
Section 2.1, "Requirements," on page

Section 2.2.1, "Business Continuity Cluster Component Locations," on page 22

Section 2.2.2, "Downloading the Business Continuity Clustering Software," on page 23

Section 2.2.3, "Configuring a BCC Administrator User and Group," on page 23

Section 2.2.4, "Installing and Configuring Business Continuity Clustering Core Software," on
page 25

Section 2.2.5, "Installing the Identity Manager Management Templates for Business Continuity
Clustering," on page 26

Section 2.2.6, "Manual (Quick) Business Continuity Clustering Installation," on page 26

Section 2.2.7, "Removing Business Continuity Clustering Core Software," on page 29

2.2.1 Business Continuity Cluster Component Locations

The following figure illustrates where the various components needed for a business continuity
cluster are installed.
Figure 2-1
Server
A
IDM
Managment
Utilities
BCC
iManager
plug-ins
Fibre Channel
Figure 2-1
BCC eng.: Novell Business Continuity Clustering engine
22 Novell Business Continuity Clustering 1.1 Administration Guide for Linux
Business Continuity Cluster Component Locations
Building A
Ethernet Switch
Server
2A
OES Linux OES Linux
iManager NCS
BCC eng.
Server Server
1A 3A
OES Linux
NCS
BCC eng.
Switch
Fibre Channel
Disk Arrays
Cluster Site 1
uses the following abbreviations:
17.
WAN
eDirectory
IDM
OES Linux
NCS
BCC eng.
OES Linux OES Linux
NCS NCS
BCC eng. BCC eng.
IDM eng. IDM eng.
IDM eDir IDM eDir
Driver Driver
SAN
Disk blocks
Building B
Ethernet Switch
Server
2B
OES Linux
iManager
Server Server
1B 3B
OES Linux
NCS
BCC eng.
Fibre Channel
Switch
Fibre Channel
Disk Arrays
Cluster Site 2
Server
B
IDM
Managment
Utilities
BCC
iManager
plug-ins