Displays - Diamondback 500 Owner's Manual

500tmOM 8/24/06 11:19 AM
Select Key
Speed & Incline

displays

Message & data
displays
Pulse Indicator display
18
Page 20
Console Layout (continued)
Displays:
a. Dot Matrix /Profile display:
1. It displays instruction letters during setup.
•
•
•
2. It displays the program profile during the program run mode.
•
•
b. Workout data display:
a.
•
•
b.
As soon as a program is started, it will start displaying the default workout data:
time, calories & heart rate. You may select your favorite data displays by press-
ing the "SELECT" button under each data display, the LED indicator will light up
to show which data is displaying.
•
•
•
•
•
•
•
c. Pulse indicator: the heart indicator will start blinking once there is heart
rate signal detected by the console.
Display "AGE" during age setup; "WT" for weight setup; "TIME" for
time setup & "HR" for HR setup.
Display "ENGL" or "METR" for English or Metric units switch.
Scroll "WARM UP" or "COOL DOWN" to indicate entering these
modes.
Press this SELECT key to switch the profile display from default to Incline
profile and light up its LED indicator or from Incline profile back to
default profile and turn off the LED indicator.
Each column represents segment time = Program time / 20 columns. If
the program time is less than 20 minutes, then the segment time will be
1 minute instead.
Speed and Incline display
Speed (mph) – Current speed.
Incline (%) – current incline %
Other data displays
Time (hr: min or min: sec): The remaining of program time.
Distance (mile): Total workout distance.
Pace (min: sec): current minutes per mile.
Calories (kcal): Total workout calories.
Cal/min: current Calorie rate.
Heart rate (bpm): Your current heart rate. If there is no pulse detected, it
will display " - - - " instead.
% max HR: Current % max HR.
500 Tm Owner's Manual