Diamondback 460 Series Owner's Manual page 10

10
460Rb Assembly Instructions (continued)
Console Assembly
1. Connect the plugs from the main wire harness and the hand pulse harness to
the plug receptors on the back side of the console, taking care to install
correctly (See plug alignment marks)
2. Carefully feed the slack in the wires into the Console Mast and place the
Console on the mounting plate
3. Fasten the console to the console mounting plate with four M5 x 15mm
screws using a Phillips screwdriver.
Note: Console may be operated using batteries or the AC Adapter that came
with the unit. If it is going to be operated using batteries the AC Adapter MUST
be unplug from the unit.
Pedal Assembly
1. Use a 15mm open-end wrench to firmly affix the pedals to the cranks.
2. The left and right pedals are different and are denoted as right or left (R or L)
on the top and bottom of each pedal. Please Note: the left pedal threads
counterclockwise.
3. Retighten the cranks after approximately 10 hours of use.
Water Bottle
1. Place the bottle holder on the Console Mast. Insert and tighten the two ST5 x
15mm screws using a Phillips screwdriver.
2. Snap the water bottle into the holder.
460 SeriesfOwner's Manual