Wali M001XL-W Installation Manual

INSTALLATION MANUAL
Single Monitor Desk Mount
M001XL/M001XL-W
Supplied Parts List
Lower Pole Upper Pole
A1 (x1) A2 (x1)
Nut M4x12 Bolt M4x30 Bolt
E (x1) F (x4)
2
Option A : Clamp Installation
1. Connect Lower Pole a and C-Clamp Brace c from the bottom using M5x14 Bolt f and tighten with Allen Key 3mm o . A1
B2
J1
I
C-Clamp C-Clamp Brace Support Plate
B1 (x1) B2 (x1) B3 (x1)
M4~M6 Spacer Allen Key
G (x4) H (x4) I (x1)
J1
A1
B2
WARNING
！
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
TIPOVER WARNING
！
www.walielectric.com
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
support@walielectric.com
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
1-844-SATTLER (18447288537) USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
M10 Hand Knob Grommet Base Plate Swivel Arm
B4 (x1) B5 (x1) C (x1)
M5x14 Bolt M8x12 Bolt Wire Clip
J1 (x3) J2 (x2) K (x2)
2. Remove the screw and washer at the top of the M10 Hand Knob
and washer that were just removed. Select the preferred height according to your desk thickness. Connect C-Clamp
I
Bolt J2 , and tighten with Allen Key 5mm I . Rotate the hand knob N clockwise to fasten for stability.
J1
B4
1
Option A : 31.5'' Pole Installation
Loosen the screw on the Lower Pole
Lower Pole to Upper Pole
a1 A1
3mm o to fix the two poles.
I
Pre-Assembly
VESA Plate
D (x1)
I
A1
A1
Wire Clip
L (x2)
and connect the M10 handle
B4 B4
I B4
B3
B1
B1
Hand Knob
A1 with Allen key 3mm o . Connect
a1 I
A2 and tighten the screw with Allen key
a2
A2
A2
I
A1
, C-clamp and support plate with the screw
B1 B3
B1
to C-Clamp Brace using M8x12
B1 B2
B1 B2
B2
J2
I