Table of Contents
Advertisement
(7) Parallel Port Connector (25-pin D-Sub ): PARALLEL
The On-board Parallel Port can be disabled through the BIOS SETUP. Please refer to
Chapter 3 "INTEGRATED PERIPHERALS SETUP" section for more detail
information.
(8) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(9) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
PS/2 Mouse
PRINT
PS/2 Keyboard
COM1
Pin 1
Floppy Drive Connector
IDE1
Pin 1
Primary IDE Connector
14
USB1
COM2
USB
FDD
LAN
MIC
LINE-IN
LINE-OUT
Advertisement
Table of Contents
